Page 1 of 1

configure wrf

PostPosted: Wed Jan 09, 2019 2:54 am
by Ancy

1) How to configure WRF for PU execution? Any documentation on the same?
2) Which are the physics packages, implemented for GPU execution?
3) Any particular version of WRF, which support GPU?
4) Does WRF4.0.2 support GPU execution?


Re: configure wrf

PostPosted: Thu Jan 10, 2019 5:15 pm
by kwthomas

There are bits a pieces of code for GPUs in WRF, none of them documented. I wouldn't waste my time

Re: configure wrf

PostPosted: Sat Feb 02, 2019 9:01 am
by ElliotGi
Would this be useful to anyone if it was compiled by the way?

Re: configure wrf

PostPosted: Fri Feb 08, 2019 6:45 pm
by kwthomas
Yes, a fully supported WRF for GPU's would be wonderful. FV3 would be great too.

BRIDGES/PSC has GPU's. I do a lot of WRF runs there in support of the NOAA Hazardous Weather Testbed

The one big "gotcha" may be that WRF usage will decrease, at least of us, as FV3 ramps up. I'll be running
FV3 SAR this spring on STAMPEDE2/TACC.